Brake Controller Install Info for 2005 Monaco Knight
Question:
Do you happen to know the adaptor part number for a 2005 Monaco knight diesel pusher motorhome? I cant seem to find it. To my understanding, the motorhome has a pre-wired 6 pin connector. Thank you
asked by: Andrew
Expert Reply:
Your 2005 Monaco Knight is built on a Freightline Monaco chassis which we do not carry a quick install harness for to install a brake controller like the # TK90160.
I did a little research and found that there should be a blue wire underneath the dash area that will be your brake output wire that will be run to the six way of the Monaco. You will connect this brake output wire to the brake output wire (blue wire) of your brake controller.
The red wire from the brake controller will be the stoplight switch wire and will be run to the stoplight circuit of the Monaco. You will want to find a circuit that sees voltage when the brakes are applied and none when the brakes are not.
The white wire from the controller will be run to the negative side of the vehicle battery.
The black wire will need to be run to the positive side of the vehicle battery through a 30 Amp Pollak Circuit Breaker, part # PK54530.
I attached a couple helpful links on brake controllers for you to check out also.
For 10 gauge wire we carry the part number # 10-1-1 which is sold by the foot.
Products Referenced in This Question
Pollak Circuit Breaker - Cycling/Automatic Reset - 30 Amp - Straight Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 30 Amp
- Pollak
more information >
Product Page this Question was Asked From
Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: MORryde RV Ceiling TV Mount - Slide/Flip Down/Swivel - 35 lb Capacity - Steel
- Shop: Brake Controller
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Lippert RV Motorized TV Lift w/ Remote Control - 100 lb Capacity - Aluminum
- Video: Review of Lippert Components RV TV Lift - LC309690
- Shop: Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Q&A: How to Install a Brake Controller on a 2003 Monaco Knight Motorhome
- Shop: MORryde RV Ceiling TV Mount - Flip Down - 25 lb Capacity - Steel
- Shop: MORryde RV TV Wall Mount - Horizontal Slide/Swivel - 35 lb Capacity - Steel
- Shop: MORryde RV Ceiling TV Mount - Flip Down/Swivel/Tilt - 25 lb Capacity - Steel
- Shop: Solera RV Window Awning - 36" Wide - 18" Projection - White Fade
- Q&A: Installing an Electric Trailer Brake Controller in a Class A Motorhome with Air Brakes
- Q&A: Brake Controller Installation for Motorhome with Air Brakes
- Q&A: How To Install a 30 Amp Service on an Enclosed Cargo Trailer
- Q&A: Brake Controller for a Motorhome with Air Brakes
- Q&A: Where is Cold Side of Brake Switch Normally Found
- Q&A: Brake Controller Install in Motorhome on 2005 Ford E-450 Van Cutaway Chassis
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)