Does SuperSprings for 2020 Ford F-450 Super Duty Replace Entire Leaf Spring

Question

Question:

I'm wanting to install the SuperSprings SSA25 on my 2020 Ford F-450 as I've heard they work really well, but do they replace my entire leaf spring setup?

asked by:

0

Expert Reply:

The SuperSprings # SSA25 are a really solid choice for suspension enhancement for your 2020 Ford F-450 and they do not replace your leaf springs. They actually install on top of the springs you have now and provide additional support.

If you check out the picture I attached you can see how it installs.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Typically with the weights you mentioned I would go with the SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA22 which is the 2,500 lb. kit. But with your camper being a permanent mount, I would go with the SuperSprings Custom…

view full answer...

Answer 2

To help reduce the body roll on your 2014 Forest River Georgetown motorhome on the Ford F-53 20,500lb chassis I recommend starting with the Roadmaster Rear Anti-Sway Bar #RM-1139-145. This will add a 2nd stronger rear sway bar to your Georgetown to…

view full answer...

Answer 3

Yes, you can use the SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA25 for your 2017 Ford F-250 Super Duty and they will fit with the top overload springs! Attached is a review video for you to check out.

view full answer...

Answer 4

I confirmed with SuperSprings that the Suspension Stabilizer and Sway Control Kit #SSA25 will fit your 2017 Ford F-250. The kit will work on your truck with 4-wheel or 2-wheel drive.

view full answer...

Answer 5

I checked with the manufacturer, SuperSprings, for you and each of the SuperSprings kits will fit your 2013 Ford F-250 or F-350 Super Duty that does not have factory overload springs. These are an excellent upgrade to your suspension because they…

view full answer...

Answer 6

We have two Timbren rear suspension kits that fit your 2020 Ford F-250 we have the standard duty #TFRTT350J which has a spring height of 3-9/16 inch and a bracket height of 2-3/8 inches. The severe duty #TFR250SDJ is 3-5/8 inches tall and has the…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Does SuperSprings for 2020 Ford F-450 Super Duty Replace Entire Leaf Spring

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching