Rhino-Rack RVP Roof Rack That Fits 2019 Mazda CX-9

Question

Question:

Hi, Can the Rhino-Rack RVP be installed on a 2019 Mazda CX9, fixed mount? Thanks,

asked by: Stephen

0

Expert Reply:

Rhino-Rack does have an RVP rack fit for your 2019 Mazda CX-9 with flush mounted roof rails with the Rhino-Rack RVP Roof Rack for Fixed Mounting Points # RRRVP51.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I spoke to Rhino Rack about using the Rhino-Rack RVP Roof Rack for Fixed Mounting Points part #RRRVP51 on a 2019 Mazda CX-9 and they stated you must use the forward and middle mounting points. The last mounting point is only used when there are…

view full answer...

Answer 2

Yes the Rhino Rack RVP roof rack part #RRRVP51 that you referenced is a fit for your 2020 Mazda CX-9 without chrome side rails and does attach to factory fixed mounting points.

view full answer...

Answer 3

I spoke with my contact at Rhino-Rack who said that they don't have any notes about there being any issues between the part #RRRVP51 and the moon roof on a 2019 Mazda CX-9 but she did say that you need to be careful not to overtighten the…

view full answer...

Answer 4

The Rhino-Rack RVP Roof Rack for Fixed Mounting Points part #RRRVP51 comes with two crossbars, one for the front and one for the rear. The crossbars are not the same so it dose matter which goes where. I wasn't able to find any refence to…

view full answer...

Answer 5

Thanks for the photo, and there is nothing that comes with the rack specifically would go over the factory moldings of your 2021 Mazda CX-9 when installing the Rhino-Rack RVP Roof Rack for Fixed Mounting Points #RRRVP51. That said, per the…

view full answer...

Answer 6

Yes, we do have a set of crossbars that mount directly to your side rails and don't extend past them. They are the Rhino-Rack RVP Roof Rack for Fixed Mounting Points item #RRRVP51. This aero bar roof rack system has a 165 lbs capacity. The…

view full answer...

Answer 7

The Rhino Rack RVP roof rack part #RRRVP51 is a confirmed fit for your 2018 Mazda CX-9 and does attach to the fixed mounting points the vehicle has on the roof. I attached a picture that I took from the linked install instructions (see below) that…

view full answer...

Answer 8

For a great roof rack for mounting a roof top tent on your 2019 Mazda CX-9 with fixed mounting points, I recommend the Rhino-Rack RVP Roof Rack for Fixed Mounting Points - Vortex Aero Crossbars #RRRVP51. It is important to note that the dynamic…

view full answer...

Answer 9

The correct Thule fit kit for your 2018 Mazda CX-9 to use with your Thule feet #TH710601 is the part #TH67KE. Sounds like you already have crossbars but just want to mention the part #TH711320 is the correct size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Rhino-Rack RVP Roof Rack That Fits 2019 Mazda CX-9

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching