Replacement Cable for Cable Actuated RV Waste Valve

Question

Question:

Is the cable assembly alone available.?

asked by: Fred

0

Expert Reply:

The cable itself is not available for the LaSalle Bristol Cable-Actuated RV Waste Valve # 34466N4BB96GM,

However, we do carry Valterra products like the Valterra Waste Valve Body w/ Flexible Cable for RV Gray Water Tank # TC172- which do have replacement cables available. If you needed to replace the cable on a Valterra waste valve you would want to use the Valterra Cable with Valve Handle # TC96PB, which can be used with both Valterra and Bladex cable actuated waste valves.

expert reply by: Erik B

0

Answer 1

The LaSalle Bristol Cable-Actuated RV Waste Valve is offered in a few different length, with 96" part #34466N4BB96GM being the longest.

view full answer...

Answer 2

The LaSalle Bristol Cable-Actuated RV Waste Valve, #34466N4AB120GM is not designed to be trimmed. However, there are multiple lengths available: - 36" Cable #34466N4AB36GM - 48" Cable #34466N4AB48GMA - 72" Cable #34466N4AB72GMA -…

view full answer...

Answer 3

If you're looking to replace your blackwater waste valve and cable, then I recommend going with an actuated cable valve. For these, LaSalle Bristol offers two options while Valterra offers none. Which of the two Bristols you choose will depend on…

view full answer...

Answer 4

If you have a Valterra waste valve on your 2015 Open Range 316 then it should have a set screw to secure the cable that runs to the handle. I have never inspected the OEM waste valves on a trailer before but I would be surprised if there were no set…

view full answer...

Answer 5

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 6

Remove the locknut from the cable housing assembly of the #34466N11AB96GMA. Feed the cable through the mounting bracket or hold in the wall of chassis. Feed the locknut back over the cable and fasten securely to the backside of the bracket or wall.…

view full answer...

Answer 7

Unfortunately LaSalle Bristol completely covers the connection point in plastic so the only way to gain access to gate inside the LaSalle Bristol Cable-Actuated RV Waste Valve #34466N4BB96GM would be to cut into the plastic for the cord and…

view full answer...

Answer 8

The gasket is the portion of the gate valve that's allowing waste water to leak through and not actually the gate. Both companies are using a rubber gasket that will eventually fail so it really comes down to the other features of the gate valve…

view full answer...

Answer 9

I don't know the length of the cable used for valves on your Montana so you'll want to measure the length to determine the correct replacement. To make the swap out easy I recommend just unbolting the old valve from the system and then swap…

view full answer...

Answer 10

Depending on the brand of the gate valve you will either be able to replace just the cable and handle or will have to replace the entire valve/cable/handle. LaSalle Bristol builds the cables into the housing for the valve, making them essentially…

view full answer...

Answer 11

No they will all mount differently. For example, LaSalle Bristol Cable-Actuated RV Waste Valve - Black Water Tank - Spigot to Spigot - 96" Cable, part #34466N4BB96GM, needs ABS solvent cement, part #3447530889, to secure the valve to your sewer…

view full answer...

Answer 12

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

view full answer...

Replacement Cable for Cable Actuated RV Waste Valve

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching