Are Spacer Needed to Install Firestone Air Bag Kit on 2004 Toyota Tacoma SR5

Question

Question:

I want to install the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle F2304. Do I need additional spacers for a 2004 Tacoma SR5 4x4, with no additional lift?

asked by: Jake S

0

Expert Reply:

You do not need to use a spacer kit when installing the Firestone air bag kit part # F2304 on your 2004 Toyota Tacoma SR5 4x4. The only models that need the spacer are the HD and or TRD package vehicles. They require the part # F2366.

expert reply by: Jameson C

0

Answer 1

For your 2002 Toyota Tacoma 4x4 TRD you will need Ride-Rite kit #F2304 and spacer kit #F2366. The spacer kit is assuming a factory lift of 2 inches. If your truck is lifted another inch beyond that then you would need a 3 inch spacer kit #F2367. I…

view full answer...

Answer 2

The helper springs in Timbren kit #TTORTAC4A are 5-1/8 inches tall by themselves. The overall height of the whole assembly will be a little taller. Does your 2004 Toyota Tacoma have a suspension lift?

view full answer...

Answer 3

I went out the warehouse and measured the 1,000 pound SumoSprings your 2016 Toyota Tacoma and they're right under 5 inches at about 4-15/16 inches. These are custom fit for your Tacoma as long as it has the factory suspension. If you've…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 11

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Are Spacer Needed to Install Firestone Air Bag Kit on 2004 Toyota Tacoma SR5

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching