Which Front Hitch for 2020 Ford F-250 Sticks Out the Least

Question

Question:

Which front hitch should I get for my 2020 Ford F-250? I'd prefer one that doesn't stick out too far.

asked by: Dale

0

Expert Reply:

Of the two hitches that fit your 2020 Ford F-250 the Curt hitch part # C31078 sticks out less than the Draw Tite part # 65078. I attached two pictures to show you the difference. The Curt is the first picture and the Draw Tite is the second.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The hitch pin will end up behind the air dam of your 2020 Ford F-250 when you install the Curt hitch part #C31078 on it. Once cut the air dam is very easy to flex so that you can access the hole as needed.

view full answer...

Answer 2

The Hollywood Racks RV Rider part #HLY647FR is rated for heavier bikes like your electric mountain bikes and is also rated for the rougher ride quality that is present at the rear of motorhomes. This rack has an 80 lb weight capacity and would work…

view full answer...

Answer 3

The only bike rack we offer or that is readily available for that matter which is rated for both the weight of e-bikes and the abuse of the ride on the rear of a fifth wheel trailer is the Hollywood Racks RV Rider 2 Bike Platform Rack for E-Bikes…

view full answer...

Answer 4

I'll be the first to admit that the stabilizer strap requirement for Curt hitches like the part #C11423 is a hassle that most wish was avoidable. If you have the strap tight enough that it's damaging the vehicle then you'd want to back of…

view full answer...

Answer 5

In order to satisfy Curt warranty requirements, any of their Class I or II receivers (like the C11423 you referenced) as well as a few of their Class III hitches must be used with a stabilizing strap like part #18050. This applies to any non-trailer…

view full answer...

Answer 6

The Curt Front Mount Trailer Hitch Receiver #C31078, which is confirmed to fit your 2018 Ford F-250, will actually sit about level with the air dam on the truck meaning it won't change the ground clearance at all. When installing the hitch you…

view full answer...

Answer 7

While there's a great chance the EcoHitch #306-X7904 you referenced will carry over to the 2020 models it currently only fits the 2019 models of both gas and diesel engines. The Curt hitch part #C31078 is a fit though for your 2020 Ford F-350…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Which Front Hitch for 2020 Ford F-250 Sticks Out the Least

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching