Rack For 2 Heavy Traditional Bikes On An RV With Very Little Lifting Required

Question

Question:

What's a good bike rack for our 2 heavy traditional style bikes on a Winnebago 2016 View V

asked by: Pam B

0

Expert Reply:

How heavy your bikes are is an important consideration but I have an option for you.

A good option to consider is the Hollywood Racks Sport Rider SE # HLY84FR. This is approved for motorhome use and handles bikes up to 80lbs each.

expert reply by: Patrick R

0

click to enlarge

Answer 1

The Hollywood Racks Sport Rider SE part #HLY84FR will work with most step-through frame bikes. The best chance you have of this is to switch the short hook to the bottom and then the long hook to the top on the upright as that will then allow for…

view full answer...

Answer 2

For an RV approved E-bike rack that has the higher weight capacity you need the best option is the Hollywood Racks RV Rider part #HLY64FR which has an 80 lb capacity, has frame clamps that can work with step thru frames, and will work great in your…

view full answer...

Answer 3

The Hollywood Racks Sport Rider SE 2 Electric Bike Rack part #HLY84FR is not rated for use on trailers because the ride at the back of a trailer is much rougher than that on a vehicle. The reason for this has to do with the design of the suspension…

view full answer...

Answer 4

A motorcycle carrier probably isn't your best option because the chances of it tilting is less and also most motorcycle carriers are not rated to be used on the back of a motorhome. There's more stress placed on a carrier that used on…

view full answer...

Answer 5

I have a similar bike rack that will work well for you but the Thule T2 Pro XTS part #TH9034XTS does not have the weight capacity needed as it has a weight capacity of 60 lbs per bike. Instead you'd need are highest weight rated E-bike rack…

view full answer...

Answer 6

The best bike rack we offer for a Rad Rover Fat Tire Step-Through Bike is the Hollywood Racks Sport Rider SE Bike Rack part #HLY84FR which has a weight capacity of 80 lbs and accepts tires up to 5" wide. That said, they don't offer…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 9

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 10

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Rack For 2 Heavy Traditional Bikes On An RV With Very Little Lifting Required

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching