Rear Torklift Camper Tie Down for 2008 Chevy Silverado 3500 with Torklift SuperHitch

Question

Question:

I purchased and installed a TLC1205 dual receiver hitch on my 2008 Chevy Silverado 3500. What is the part number for the rear tie downs to fit hitch

asked by: Joe S

0

Expert Reply:

The correct rear Torklift tie downs you need for your 2008 Chevy Silverado 3500 are the part # TLR3503 since you have the Torklift hitch # TLC1205.

expert reply by: Jameson C

0

Answer 1

Yes, the Torklift Class V hitch part #TLC1205 would be a great option for your 2002 Chevy Silverado 2500HD long bed. If you instead had a short bed truck you would want the part #TLC1204. The 17k capacity is more than what your truck is rated for…

view full answer...

Answer 2

The TorkLift SuperHitch Magnum Trailer Hitch #TLC1205-30 that you referenced has been confirmed as a fit for your vehicle so it would be a great choice as it has a ton of capacity like you said you needed. Maximum gross trailer weight: 20,000 lb…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 12

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

view full answer...

Rear Torklift Camper Tie Down for 2008 Chevy Silverado 3500 with Torklift SuperHitch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching