Construction of Prongs on Mighty Cord RV Power Inlet # A10-30INBKVP

Question

Question:

Are the prongs stainless steel for the 30 Amp Female Twist Lock Power Cord for Mighty Cord Replacement RV Power Inlet # A10-30INBKVP?

asked by: Joel

0

Expert Reply:

I reached out to my contact at Mighty Cord regarding the RV Power Inlet # A10-30INBKVP and he said the prongs are a nickel plated copper, which will do a great job of resisting any corrosion. The inlet is also CETL listed.

expert reply by: Chris R

0

Answer 1

To install the Mighty Cord Replacement RV Power Inlet #A10-30INVP that you referenced requires you to install a 2-7/8 inch diameter hole. That would be the size hole saw you would need.

view full answer...

Answer 2

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 3

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 4

Short answer, yes you can convert from 30amp to 50 amp. It will be costly and require an electrician. Long answer, you will need to replace the power outlet with SmartPlug RV and Marine Power Inlet - 50 Amp - Stainless Steel #SM79FR. Then replace the…

view full answer...

Answer 5

For your AC power Setup and Air Conditioner additions, I recommend the Advent Air RV Air Conditioner w/ Ceiling Vent and Start Capacitor #ACM135C. This air conditioner will allow you to simply cut a 14-1/4 by 14-1/4 inch square hole (standard roof…

view full answer...

Answer 6

I really like the Furrion Chill HE RV AC units like the 15k BTU part #FR32PR. We have found that the Furrion units blow the coldest and are the quietest. This kit comes with an air distribution panel and comes with everything needed to install.

view full answer...

Answer 7

Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the power…

view full answer...

Answer 8

In one way or another, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger part #PD4135K is grounded to the chassis although it's a bit different for the AC and DC side. I have attached for you below an…

view full answer...

Answer 9

The Lippert Flow Max RV Toilet #LC67AF requires approximately 11-1/4" of space from the wall to the center of the drain.

view full answer...

Answer 10

The Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel #PD4135K is going to wire in the following fashion: On the front of the unit you'll have a green, white, and black wire. The green wire will connect…

view full answer...

Construction of Prongs on Mighty Cord RV Power Inlet # A10-30INBKVP

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching