Can Camco Heated Hoses Be Connected Together

Question

Question:

Hi! Can two 5o ‘ heated water hoses be connect together? What is the typical term for usage/ life of these hoses Thanks ??

asked by: Liz M

0

Expert Reply:

I did contact Camco who confirmed both their Camco RV Heated Drinking Water Hose for Cold Weather 25 foot # CAM22902 and 50 foot # CAM22903 heated water hoses can be connected together. It does require an extension cord with 14 gauge wire to do so. Regarding the life expectancy, they are warrantied for 3 years on the electrical components and 1 year for the hose.

expert reply by: Patrick R

0

Answer 1

According to the manufacturer, you can indeed connect multiple hoses together. However, we do offer the hose in a 25 foot length as part #W01-5325 or a 50 foot length as #W01-5350. Rather than daisy chaining multiple hoses together, I'd…

view full answer...

Answer 2

It sounds to me like the extension cord you're using or the power cord for the Camco RV Heated Drinking Water Hose #CAM22903 has a short in it or that you're overloading the breaker. I would first test hose without the extensions cord…

view full answer...

Answer 3

With the Camco RhinoEXTREME 2' Compartment Hose #CAM39855 only being 2' in length you could honestly just get a bar clamp or pipe clamp from your local hardware store and tame that "python". After it's…

view full answer...

Answer 4

The Camco Propane Cylinder Gas Gauge, part #CAM59023 is designed to work with a single propane tank. This attaches between the tank and the regulator. Per my contact at Camco, there is not a guage available for a 2-tank system.

view full answer...

Answer 5

There are actually two ways that 7-way wiring colors are commonly seen. One uses a red wire and the other a purple. The circuits they represent do vary though. So check out the updated diagram I attached to this page and most likely you need to…

view full answer...

Answer 6

The 50 foot Camco RV Heated Drinking Water Hose for Cold Weather #CAM22903 does not have a thermostat - we don't carry any hoses with thermostats - but if you wanted to add a hose to this you could with something like the 10 foot Camco…

view full answer...

Answer 7

In regards to the Lippert Components High-Speed Power Stabilizer Jack part #LC298707, the red wire on the motor will run through the 6 amp circuit breaker to the switch. I have attached a diagram of this for you as well although wire colors are not…

view full answer...

Answer 8

The Camco RV Heated Drinking Water Hose for Cold Weather part #CAM22903 is rated for use in temperatures as low as -40 degrees fahrenheit. We currently do not carry the 50' long hose rated for -20 degrees fahrenheit.

view full answer...

Answer 9

The water hoses part #CAM22783 can be connected together to extend the hose from the water hose. The only down side to extending the hose this much is going to be the decrease in water pressure.

view full answer...

Answer 10

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

view full answer...

Answer 11

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...