Current Draw of East Seventeen Hugger Style RV Ceiling Fan part # 344410TSDC36BNOKCY

Question

Question:

How man amps or watts does this unit draw?

asked by: CW

0

Expert Reply:

The East Seventeen Hugger Style RV Ceiling Fan part # 344410TSDC36BNOKCY at full power will draw right around 1.7 amps.

expert reply by: Jameson C

0

Answer 1

The wiring diagram for the 12 volt Lasalle Bristol RV Fan #344410TSDC36BNOKCY that you mentioned is a bit confusing but if you check out the picture I attached and follow the written instructions on where each wire goes that should be much more…

view full answer...

Answer 2

When mounting your East Seventeen #344410TSDC36BNOKCY fan you can use any connector rated for the weight load presented. Typically well nuts do not have the same strength as other fasteners, but I can certainly see the advantage with a fan that might…

view full answer...

Answer 3

As shown in the product page picture of the fan #344410TSDC36BNOKCY, the back of the wall switch has 4 wires. The red and black wires run to your 12 volt source. The blue and white wires run to the fan. The fan has 3 wires. The white and blue wires…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The TorkLift Custom Frame-Mounted Camper Tie Downs #TLC2204 and #TLC3206 that you referenced are designed to fit the 2003 Chevy Silverado 2500 with the 8 foot bed (without a board/step under the bed and without a trailer hitch). If you have the…

view full answer...

Answer 11

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Current Draw of East Seventeen Hugger Style RV Ceiling Fan part # 344410TSDC36BNOKCY

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching