Will Fastway E2 Weight Distribution System Fit on 2000 Aero Cub C230 Trailer  

Sounds like you have a friction sway control weight distribution (WD) system like the Reese Steadi-Flex #RP66561 or the Equal-i-zer #EQ37140ET. Pretty much all sway control setups use friction and that's what those loud popping and creaking…

Per the manufacturer The Fastway square trunnion L Brackets #FA93-02-5150 and The Equalizer L Brackets #EQ90-02-5150 are made by the same manufacturer and they're the same. I have attach a review video below.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Donald, the best Blue Ox weight distribution would be the pat #BXW0550 as it has a perfect tongue weight range for your 450 lb tongue weight trailer.

Most of the 2-5/16 inch hitch balls will use either a 1-inch diameter shank or 1-1/4 inch diameter shank. The nut size on a hitch ball with a 1-1/4 inch shank, like the Tow Ready 2-5/16 Inch Hitch Ball, part #19286, will use a 1-7/8 inch socket. A…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

There is not a factory brake controller plug-in port on your 2018 Ford Transit T250 so in order to install your existing Tekonsha Primus Brake Controller you will need to hardwire it in using the Wiring Kit #5506. This kit will provide you with the…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…