Replacement Clearance Light for Escape Trailer

Question

Question:

I have 2016 Escape 17-B trailer, from Escape Industries in Chilliwack, British Columbia. The plastic lens on the side rear of the trailer is broken. Im not sure if the light is still working, but I suspect I need to replace the entire unit. I found Item MCL32RB on your website and wonder if this is the correct part. I have attached 3 pictures I hope. I hope you can help me find the appropriate part. thanks!

asked by: Kathryn C

0

Expert Reply:

Thanks for the photos and it looks like you have found exactly what you need with the LED Trailer Clearance or Side Marker Light # MCL32RB. This light measures 2 inches tall (and 4 inches long), which is what it looks like yours measures, and it has mounting holes that are 3 inches apart on center, which I'm guessing is what you got when you measured that. This light will work well as a replacement for you.

I've added a link to a video review as well.

expert reply by: Kyle S

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 10

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Replacement Clearance Light for Escape Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching