Can Prodigy Brake Controller Install in Motorhome for Towing a Trailer

Question

Question:

I have a 2003 RV with a US Gear break controller already installed. I want to tow a trailer, not a vehicle. Can I use the US Gear Break Controller, or do I need to add a different type like the prodigy 2. I have a prodigy 2 controller in my truck, but not sure it will work on my RV as well.

asked by: Dave

0

Expert Reply:

The US Gear brake controller you have is for applying brakes of a towed vehicle and not for a trailer so you'd need to install a trailer brake controller like the Prodigy P2 part # 90885 that you mentioned having installed in your truck. This is a very common brake controller installed in motorhomes like yours because of how well it works and how reliable it is.

The install process is the exact same as what you'd do to hardwire a controller to a vehicle. I attached a help article on hardwiring brake controllers for you to check out as well.

expert reply by: Jameson C

0

Answer 1

It is very common for automatic transmission vehicles to need to be started and ran for a couple minutes every couple of hours or at every fuel stop. This is because the engine lubricates while running, so every couple hours of towing the engine will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…

view full answer...

Answer 10

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Can Prodigy Brake Controller Install in Motorhome for Towing a Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching