Replacement 80 Amp Circuit Breaker for StrongArm Winch TW9000

Question

Question:

Hi For a TW9000, Instead of using an 80 amp fuse, is there a breaker that can be reset?

asked by: Ric K

0

Expert Reply:

The TW9000 winch does require the use of the 80 amp Replacement Circuit Breaker for DL StrongArm Winch Wiring Harness # DL304025.

These are thermal breakers so they can be reset.

expert reply by: Kyle S

0

Answer 1

I strongly recommend using the circuit breaker since it will auto reset unlike a fuse that would blow and would have to be replaced. Also the winch #1120210 was designed to be wired up using the circuit breaker and not for use with a fuse. I have…

view full answer...

Answer 2

The Bulldog Quick Connects #BDW20047 that you referenced are designed to be used on wire that is from 6-10 gauge. Since you have 6 gauge wire you would be just fine. This does not come with any wire, and to determine if your winch requires circuit…

view full answer...

Answer 3

I'm only seeing the one circuit breaker assembly between the winch solenoid and battery for the Superwinch LT4000 ATV Winch #SW1140220. Winches usually have higher amp ratings and breakers because they have a pretty significant power draw during…

view full answer...

Answer 4

I spoke with my contact at ComeUp about a circuit breaker for the DV-6s Carry On Winch #CU854768 that you referenced. He confirmed that a 150 amp circuit breaker will work for this winch. You can use the Pollak Circuit Breaker, 150 Amp #PK54872PL.…

view full answer...

Answer 5

To flat tow a 2024 GMC Sierra 2500 you will need the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar for Direct-Connect Base Plate item #e84ZR Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms…

view full answer...

Answer 6

Hi Robert, To install your Putco Blade LED Tailgate Light Bar #P22KR you'll need to just remove the tail lights so that you can get access to the back wiring in the back of them. The plug-and-play connectors on the wire harness with have a male…

view full answer...

Answer 7

Hi Chris, Yes, the Demco LED Light Bar for Towed Vehicles w/ Wireless Transmitter #DM36MV is approved and legal for flat towing your vehicle. It's designed to attach to the rear window with a suction cup and face rearward so that others on the…

view full answer...

Answer 8

There are a select few fifth wheel hitches that have replacement leg kits that would adapt them to fit the OEM prep package of your Dad's 2023 GMC Sierra 3500 but I would need to know what hitch you guys have to be able to determine if that's…

view full answer...

Answer 9

To add a 5th wheel hitch to your long bed 2024 GMC Sierra 2500, I recommend the B&W Companion OEM 5th Wheel Hitch item #BWRVK3710 for a 20,000 lbs capacity or item #BWRVK3715 for a 25,000 lbs capacity. These 5th wheel hitches will mount directly…

view full answer...

Answer 10

For you 2024 GMC Sierra 2500 AT4 that has a 3 inch lift I would go with the Roadmaster sway bar part #RM25FR as it's slightly thicker than the Hellwig that also fits your truck which will be helpful since lifted vehicles have a higher center of…

view full answer...

Answer 11

If your 2021 Keystone Cougar 22MLSWE had 2,000 lb axles the part #TMK54ZR would be correct for it but I do not believe that is what you'd need although I was not able to verify the axle capacity of the trailer. A more likely axle capacity you…

view full answer...

Answer 12

The spacer/washer you're referencing on the #GY23XR sits underneath the plate. The only thing on top will be the nut and cotter pin as seen in the picture below.

view full answer...

Replacement 80 Amp Circuit Breaker for StrongArm Winch TW9000

Product Page this Question was Asked From

Continue Researching