Will the Replacement Mounting Brackets for Carr Custom-Fit Side Step Work with the Super Hoop XM3

Question

Question:

Will these brackets work for the super hoop XM3. The old style brackets are to thin of metal and are actually tearing

asked by: Alex

0

Expert Reply:

Yes, the Replacement Mounting Brackets for Carr Custom-Fit Side Step part # CARRBR14702K2 will work with the Super Hoop XM3 Side Steps which I confirmed with my contact at Carr for you.

expert reply by: Conner L

0

Answer 1

The Curt Trailer Hitch Receiver part #C15300 which is a fit for a 1977 Ford F-250 is designed for the factory gas tank. If you have an aftermarket gas tank then we would not be able to confirm fit but what I could do is provide you with the inner…

view full answer...

Answer 2

The Replacement Mounting Brackets #CARRBR14702K2 will fit the Carr Custom-Fit Side Steps #CARR124031 on your van.

view full answer...

Answer 3

Center hole to center hole, the distance apart for all three holes measured from the holes on one flange across to the other is 43-5/8 inches. The flanges measure 41-1/8 apart, measured inside to inside and the 3 holes along each flange are 3-1/2…

view full answer...

Answer 4

I would be happy to help you. I have linked some diagrams with every dimension you will need. The Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2" item #C15300 is confirmed to fit a 1979 Ford Bronco.

view full answer...

Answer 5

I checked with Curt and the distance between the vertical mounting flanges of the Curt #C15300 is 33.312 inches.

view full answer...

Answer 6

In regards to the etrailer Trailer Hitch Receiver part #e75ZR for a 2023 Toyota Highlander, you must trim the underbody panel per the manufacturer. The hitch will come into contact with the panel if not trimmed. The panel however does not need to…

view full answer...

Answer 7

Some running boards and steps do mount to the vehicle's frame members and not to its sheet metal. For example, the Carr Tube Steps #CARR105772, attach to the rocker panels. I have linked for you our main page for all step products that fit…

view full answer...

Answer 8

At around the 1:40 mark on the attached installation video for #BBS-1103, you can see that the Bully Black Bull Side Steps mount on a little over 8 inches on center. These are designed to fit a wide range of vehicles, but your 2018 Ram ProMaster 2500…

view full answer...

Answer 9

Carr does offer some of their steps individually like the Carr Custom-Fit Side Step #CARR103992-1, however for your 2021 Ram ProMaster 2500, they only offer their step as a pair #CARR105772. These steps measure 10" long, has a 5" drop and a…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...