Will the Roadmaster Active Suspension Leaf Spring Kit Fit a 2005 Ford E-350 Cutaway Class B

Question

Question:

Will it fit? 2005 Ford E-350 Super Duty, cutaway cab Class B- RV

asked by: Lee S

1

Helpful Expert Reply:

I do have a very similar option for you in the SuperSprings Custom Suspension Stabilizer and Sway Control Kit part # SSA22 but I checked with RAS and they do not offer a Roadmaster Active Suspension Custom Leaf Spring Enhancement Kit for a 2005 Ford E-350 Cutaway.

expert reply by: Conner L

1

Answer 1

The SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA22 are designed for use on a cutaway chassis. If that is what you have then these will fit. The inverted springs on your 2010 Ford E-450 may be caused from the springs being…

view full answer...

Answer 2

For a great enhancement that will support your leaf springs on your 2022 Ford E-Series Cutaway, I recommend the SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA22. Apart from providing you with 2,500 pounds of load-leveling…

view full answer...

Answer 3

With the SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA22 it can result in a rougher ride as it is designed to provide a stiffer ride by reducing the suspension sag and providing more stability to the leaf springs. Due to the age…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 9

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Will the Roadmaster Active Suspension Leaf Spring Kit Fit a 2005 Ford E-350 Cutaway Class B

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching