What Size Fittings Does Camco RV Water Pump Winterization Kit # CAM36543 Use

Question

Question:

what size is the brass cap on the tee for winterizing?

asked by: Michael V

0

Expert Reply:

The fitting size of all of the ends of the tee Camco RV Water Pump Winterization Kit # CAM36543 are the same garden hose size fitting of 5/8 inch.

expert reply by: Jameson C

0

Answer 1

The inlet and discharge threading on the Flow Max RV Fresh Water Pump - 12 Volt #LC689052 is .825 inches using a digital caliper so it is not the 1/2 inch male national pipe thread which would be .840 inches. Lippert recommends using the barb…

view full answer...

Answer 2

Yes the Camco RV Water Pump Winterization Kit part #CAM36543 will attach on the blue hose side or down stream side of your pump in the picture. It has the pump adapter and the tape you will need to seal everything up.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Not confusing at all. I took a look online and the 2001 Silverado 2500HD has a 12,000 lbs bumper pull towing capacity and a 15,200 lbs 5th wheel towing capacity. It's just two different capabilities of the truck. The extra weight of a 5th wheel…

view full answer...

Answer 6

There are 4 wires coming out of the back of the Draw-Tite Activator IV Brake Controller part 5504. You are correct in that the black wire runs to the positive side of the vehicle battery through a circuit breaker. The white wire runs to the negative…

view full answer...

Answer 7

The grease cap part number that you referenced cross references to a drive in cap with a 2.44 inch outside diameter. If you have a standard cap then the Grease Cap, 2.44 inch OD Drive In, item #RG04-060, is the correct part. If you have a grease…

view full answer...

Answer 8

The dimensions you have are nearly identical to the CE Smith #CE19504-2 you looked at. However, these are designed for 14" wheels. For 15" wheels you would need the Fulton #F008585-2. These are slightly longer and taller at 10-1/4"…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

I was able to get a dimension sheet from my contact at Curt for the Curt Hitch part #C15800 that you referenced. See attached pic. I also attached a set of the installation instructions for this hitch.

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

What Size Fittings Does Camco RV Water Pump Winterization Kit # CAM36543 Use

Product Page this Question was Asked From

Continue Researching