What does Duty Cycle Mean on RV Water Pumps?

Question

Question:

What does it mean Duty Cycle = 5 minutes on/10 minutes off

asked by: Kevin S

0

Expert Reply:

The duty cycle is simply the amount of time that the water pump will run and not run over the course of the day. Some water pumps operate continuously and therefore put a drain on your battery. For the Flow Max RV Fresh Water Pump # LC689054 it will run for 5 minutes and then rest for 10 minutes to help maintain water pressure in your RV.

expert reply by: Erik B

0

Answer 1

We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed…

view full answer...

Answer 2

The connectors of the Voyager RV LCD Observation Monitor - 7" Screen item #VO34FR are the same as the connectors on the older model Voyager AOM-711 RV Backup Monitor.

view full answer...

Answer 3

Yes the Seaflo Diaphragm Pump for Boats and RVs #SE57FR would be a great replacement for the Shurflo 4028 that you have now. It'll be quieter and also provide more water pressure while also being an easy install.

view full answer...

Answer 4

Unfortunately having your RV information does not tell me what fresh water pump that you have or if the HydroMax RV Fresh Water Pump #P25201 would be the correct replacement. However, I can tell you that the HydroMax RV Fresh Water Pump #P25201 is…

view full answer...

Answer 5

Yes, the Flow Max RV Fresh Water Pump #LC689052 will be a good replacement for your Shurflo 2088-422-144 water pump on your camper. This pump can be used as a replacement for any OEM water pump so it will work out perfectly for you. I have added a…

view full answer...

Answer 6

It is possible you need new brakes, but not necessarily. The brakes locking up when in reverse is usually because the brakes have recently been installed and they were installed backwards. Brakes are specific to either the left or right side. If…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

What does Duty Cycle Mean on RV Water Pumps?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching