Troubleshooting Running Lights and Left Brake Blinker Not Working on Trailer
Question:
Running lights and left rear brake/blinker light on my travel trailer not working. Looking for fuse location on my truck. Bulbs on camper are ok.
asked by: Bill
Expert Reply:
First thing you should do at this point is test the 7-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue. Since it's one side of the trailer not functioning I suspect the issue is that the ground for the light assembly on the one side of the trailer is insufficient.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Trailer Hitch Drop
- Q&A: 2015 Lincoln Navigator Brake Controller Wiring Harness Connection Location
- Q&A: Replacement Mounting Hardware For A Reese Base Rail Kit
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Can Trailer Hitch Be Installed On 2005 Chevrolet Colorado With Rear Pan Installed
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Options For Pulling a Boat Trailer Behind a 2014 Dodge Ram 3500 with an In-Bed Truck Camper
- Article: Trailer Maintenance Schedule
- Q&A: Recommended Replacement Motorhome Step For A Lippert 163033 RV Step