Weight Capacity of Tandem-Axle Hanger Kit Part # APT5

Question

Question:

what is the max weight on this kit apt5

asked by: Eric

0

Expert Reply:

The Tandem-Axle Hanger Kit, part # APT5 is designed for use on 2000-7000 lb axles, which would be up to 14000 lbs.

Keep in mind that the weight capacity of any towing system will be limited to the capacity of its lowest-rated component.

expert reply by: Mike L

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 3

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

view full answer...

Answer 4

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the…

view full answer...

Answer 5

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 6

Thank you for submitting the photo of your boat trailer showing the center spring hanger, shackle straps and equalizer. Based on the photo it does appear that non-standard replacement parts may have been used to repair or modify the suspension at…

view full answer...

Answer 7

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 8

It is not uncommon for the trailer hangers on a tandem axle trailer to be all the same size or for there to be different sizes that can be 1-1/2 to 2 inches different in height when you compare the center hanger to the front and rear. For example,…

view full answer...

Answer 9

Typically when building a tandem axle trailer I recommend using either the #APT3 or #APT5 Tandem-Axle Trailer Hanger Kit. These are the most common kits used for utility trailers and parts are readily available. The #APT5 kit is by far the most…

view full answer...

Answer 10

Thanks for all of the information, Robert! It sounds like you have the Tandem-Axle Trailer Hangers #H248 installed on your tandem axle trailer so to get your Dexter Trailer Axle w/ Electric Brakes #7359765-EB installed you need the following parts: -…

view full answer...

Answer 11

The note that says that the Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel #AM32424 shouldn't be used on wet or icy roads is a little misplaced. This is related to the painted steel wheel that it has and its slightly…

view full answer...

Weight Capacity of Tandem-Axle Hanger Kit Part # APT5

Product Page this Question was Asked From

Continue Researching