Dual Cam High Performance Sway Control Hardware

Question

Question:

does the hardware come with this? ie: nuts & bolts

asked by: Vanoye W

0

Expert Reply:

Yes, all the mounting hardware for the Dual Cam High Performance Sway Control System, 26002, is included. You get 2 square head set bolts, 4 flanged head thread forming bolts for square tube framed trailers, 4 cap head screw bolts with nuts and washers for C channel trailer frames, and 2 U bolts with nuts and washers. I have posted a link to the instructions and an install video for your convenience.

expert reply by: Robert G

0

Answer 1

According to Reese, it is perfectly acceptable to use their #RP58507 rivet nuts to fasten the dual cam bracket to the trailer frame. Reese developed the rivet nuts because they found that over time, it was possible for the attachment holes in the…

view full answer...

Answer 2

The biggest difference between an Equal-I-Zer friction style sway control and a system like a Reese Dual Cam High-Performance Sway Control #RP26002 is that the friction style is passive and the dual cam is active. What is meant by that is that the…

view full answer...

Answer 3

Sounds like you are looking for the thread forming screws that hold the Reese Dual Cam part #RP26002 to the trailer frame which for that you'd need the part #58437 and you'd be set.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch being the following: - B&W Continuum Weight…

view full answer...