Will a Trailer Hitch Ball with a Raw Finish Last as Long as a Ball with a Chrome Finish  

A chrome finish ball #C40036 is going to look good but it will not be corrosion resistant. A ball with a machine finish like #C40087 , is going to have about the same corrosion resistance. In terms of performance they will wear at about the same rate…

The small amount of surface rust on your ball will not affect its future performance. If the ball had been exposed to the elements for many months or years and the corrosion was more severe, I would be reluctant to use it. Since the rust is minor,…

In regards to the Curt Push-To-Test Trailer Breakaway Kit part #C52042, the blue wire on the breakaway switch will be run to the brake output circuit and the black wire to a constant 12 volt power source. The blue wire on the battery box will also…

In regards to the Curt Push-To-Test Trailer Breakaway Kit part #C52042 (52042), the blue wire on the breakaway switch will be run to the brake output circuit and the black wire to a constant 12 volt power source. The blue wire on the battery box will…

The install the Redarc Tow-Pro Elite #RED44FR using the Wiring Adapter #331-TPH-020 for your 2018 Ram 1500 you'll need to find the vehicle-side connector for the adapter. This will be located up under your driver's side dash to the right of…

Yes, a weight distribution system like the Curt TruTrack Weight Distribution System part #C17499 will add stress to both the trailer and vehicle frame. That said, this stress is not usually enough to cause damage. The only exceptions to this would be…

Choosing the proper shank is a very important task. The shank will correspond to the height of both the vehicle and trailer. In order to choose the proper shank, you will need to do a bit of measuring. To select the correct rise/drop, you will first…

I would be happy to help! Since your tow vehicle is a 2021 Ram 1500 Crew Cab with the 5.7L Hemi I recommend going with an even stiffer weight distribution hitch than the Blue Ox TrackPro Weight Distribution w/ Sway Control - 7-Hole Shank - 13K GTW,…

I went to our warehouse and checked the Replacement Head #FA94-02-1055 for Fastway e2 Weight Distribution Systems and found that it takes a hitch ball with a 1-1/4-inch diameter shank. You can use the link provided to view all 2-5/16-inch hitch balls…

The bolts that hold the head to the shank for the Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0600 are 3/4-10 x 5” Grade 5 Bolts. If you're asking about the size of the hitch pin then that would be 5/8". We do have the…

The MaxxAir Standard RV and Trailer Roof Vent Cover #MA00-933066 will fit your Ventline Ventadome Trailer Roof Vent #V2094SP-30. This will allow you to leave your vent open and run the fan even in the rain. You can also leave the vent open when you…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…