Replacement Lid Support for Yakima SkyBox LoPro

Question

Question:

Do you have Yakima Skybox LoPro rear lid support?

asked by: Aaron

0

Expert Reply:

Yes, the correct replacement lid support for your Yakima SkyBox LoPro is the Replacement Lid Support for Yakima Cargo Boxes part # 8880683. This will work on both the front and rear.

expert reply by: Conner L

0

Answer 1

I checked with Yakima and Replacement Lid Support for Yakima Cargo Boxes #8880683 is the correct replacement for the rear lid support on your Yakima SkyBox 16 Roof Cargo Box #Y07335.

view full answer...

Answer 2

We do carry replacement parts for the Yakima Railgrab foot. For the claw base and nut you would want the part #Y8880279. The medium claws are no longer available. For the claws with pin adapters you would want the part #Y8880201. For replacement…

view full answer...

Answer 3

Yakima has rolled over their part numbers since that answer and replaced it with two hinges that work with all of their cargo boxes. For your Skybox 16, you'll just need two of part #8880683.

view full answer...

Answer 4

While I am not personally familiar with how well the Replacement Lid Support for Yakima Cargo Boxes Item #8880683 is made, the reviews from other customers who are using them say they are a great replacement and are better than the original.

view full answer...

Answer 5

For starters, there are a few different generations of the Yakima SkyBox 16 and I would need to know which one you have in order to recommend the correct replacement hinges. I called Yakima and they were not able to reference the part number you…

view full answer...

Answer 6

Is this the latch you are looking for? 8870090 Replacement parts for your box aren't all available but I believe this might be what you are looking for.

view full answer...

Answer 7

Yakima has rolled over their part numbers since that answer and replaced it with two hinges that work with all of their cargo boxes. For your Skybox 16, you'll just need two of part #8880683.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Replacement Lid Support for Yakima SkyBox LoPro

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching