Is the Peterson Great White LED Mini Utility Light Part M290 Submersible

Question

Question:

Is this light Submersible?

asked by: Tim

0

Expert Reply:

The Peterson Great White LED Mini Utility Light part # M290 is sealed so it can be submerged. I have attached some other like options for you below that are also submersible.

Optronics Miro-Flex LED Trailer Utility Light part # UCL19CB
Optronics LED Mini Trailer Utility Light part # UCL13CPG
Optronics Thinline LED Utility Light Bar part # BUL69CB
Optronics LED Utility Light part # UCL60CSBB

expert reply by: Conner L

0

Answer 1

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 2

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 3

I have a solution that may work for you, but we do not currently have any 3" diameter submersible reverse lights. Have a look at the Optronics Backup Light #BU45CB which is a 4-1/4" diameter light that can be mounted to your trailer…

view full answer...

Answer 4

For the Tecnic 45 degree accent light part #TN42FR the correct mounting cover is the part #TN34FR.

view full answer...

Answer 5

Thanks for reaching out, Sisco! The Tow-Rax Aluminum Storage Cabinet w/ Folding Tray #TWSP30CSA doesn't have a specific mounting kit since enclosed trailers vary greatly by construction. You'll need to either anchor it to wall…

view full answer...

Answer 6

There isn't an exact angle to go off of when it it comes to shackle straps, but we try to them to sit in a 'W' shape to allow for the suspension to travel without binding up. Depending on the length of the shackle straps the…

view full answer...

Answer 7

The Dexter Hub #8-288-3UC1 has 5/8" wheel bolts. For 5/8 inch lug nuts torque them to 175 - 225 foot pounds.

view full answer...

Answer 8

While we don't carry that exact part number we do have a replacement hub/drum that would work just as well with the part #AKHD-655-6-EZ-K. This is a 6k hub/drum that fits the spindles of the Timbren Axle Less Kit part #ASR1THDS03.

view full answer...

Answer 9

It is possible to upgrade the leaf springs on a trailer to a higher rated set but I do not recommend this as it can create a rough ride. The better option would be to install the SumoSprings Trailer Helper Springs part #TSS-107-40 for overslung or…

view full answer...

Answer 10

To add a third brake light to a trailer is pretty simple, but does require an adapter to convert the signal. Because trailer tail light systems combine the stop lamp and turn signals for each side onto a single circuit, you will need to use a…

view full answer...

Answer 11

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Is the Peterson Great White LED Mini Utility Light Part M290 Submersible

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching