What Do Lippert Solidsteps # LC713662 Look Like

Question

Question:

Could you send my a picture of the Lippert LC713662 solid steps. I can not find any information about these steps any place. Id al least want to see a picture of them before I order them. I think I know what they look like but I just want to make sure. Thanks

asked by: Bruce P

0

Expert Reply:

The Lippert SolidSteps part # LC713662 that you referenced look like the picture that I attached.

expert reply by: Jameson C

0

click to enlarge

Answer 1

When installing the MORryde Quick Connect RV Steps #MR85HR, there is not a set way to ensure the screws are not hitting anything such as wiring. That being said, the MORryde Quick Connect RV Steps #MR85HR do not use lag bolts for installation. There…

view full answer...

Answer 2

The doorway width - the width from flange to flange of your doorway - needs to be between 23-3/4 inches and 26-1/4 inches, so yes, your 24 inch door will allow you to use the MORryde steps you asked about, which are the following part number: -…

view full answer...

Answer 3

In terms of choosing a Lippert Solid Step, you'll use the width of the finished door at it's narrowest. Round that number up to the next full inch, which in your case would be 28 inches. In that case, you'll want the adjustable model…

view full answer...

Answer 4

The measurement for your MORryde StepAbove RV Steps #MR86RR would be from the floor to the top of your threshold and the space between your door threshold and door to ensure that the hinge plate will fit between the door and threshold. With your…

view full answer...

Answer 5

Since you'll have to factor the door thickness into the entry width you'll want to measure how far it sticks out while opened. The SolidStep Manual Fold-Down Steps for 24" Wide RV Door Frames #LC713662 are approximately 20 inches wide so…

view full answer...

Answer 6

All the MORryde Cushioned 5th Wheel Pin Boxes #MR57VR, #MR37VR and #MR97VR will share the same dimensions and are nearly identical to the Lippert 1716 5th Wheel Pin Box #LC1324791. I have attached a technical drawing for the MORryde pin boxes similar…

view full answer...

Answer 7

To solve your step issue I recommend the MORryde StepAbove Fold-Down Steps for 23-3/4" to 26-1/4" RV Door Frames - 8" Drop Item #MR98RR. This will bolt right onto the bottom portion of the door frame instead of the sides and has…

view full answer...

Answer 8

Yes. I believe it is the Thule HideAway Awning like #TH490008 being used. However you will want the direct mount version which is part number #TH490018 to add it aftermarket to a trailer. This will include the correct mounting brackets you will…

view full answer...

Answer 9

The closest RV step we offer to 27 inches in width is the Flexco triple step #SMFP-3200L that measures 27-1/8 inches in total width. You might need the outriggers part #LC301704 to move the brackets out to install the steps if yours is 27 inches…

view full answer...

Answer 10

I'm assuming you're asking if you swap your Carrier unit to the Advent Air Replacement RV Air Conditioner for Carrier Setup #ACCAR150 will you still be able to use your current remote. If that's the case then yes you will absolutely be…

view full answer...

What Do Lippert Solidsteps # LC713662 Look Like

Product Page this Question was Asked From

Continue Researching