Will the Single-Bottle Liquid Propane Gas Rack 2020-JR Fit a 30 Lb Propane Tank

Question

Question:

Will this fit a 30LB tank?

asked by: Eric B

0

Expert Reply:

Yes, a 30 lb propane tank will physically fit inside the Single-Bottle Liquid Propane Gas Rack part # 2020-JR as the 20 lb propane tank that this is made for has the same 12-1/2" diameter as the 30 lb propane tank. The issue will be with the weight of the 30 lb propane tank while full so a better option for you might be the Rack'em Rack for Enclosed Trailers part # RA-1L which is a bit more heavy duty and will also hold your 30 lb propane tank.

expert reply by: Conner L

0

Answer 1

It sure can. The #2020-JR propane tank bracket is strong enough to support a full 20 lb propane tank. It's not necessary to set it on the floor. This assumes that the surface you attach the rack to is capable of supporting the weight of the…

view full answer...

Answer 2

To have a propane tank mounted on the outside of a trailer would be something you would want to check with your local DOT on. Most likely they wouldn't want you mounting a propane tank anywhere that would allow it to get hit in the event of…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

view full answer...

Answer 4

The Single-Bottle Liquid Propane Gas Rack part #2020-JR seems to work out well with tanks like yours. In the video I did on the rack we used a tank with an 8" ring on the bottom and had good results. This may vary with tank manufacturer's…

view full answer...

Answer 5

The 12-Volt Heater and Defroster part #PTW5009 draws around 13 amps or 156 watts so a 300 watt generator will power this just fine.

view full answer...

Answer 6

I spoke with my contact at Ventline and he informed me that this Ventline Vanair Trailer Roof Vent #VP-543SP is only to be mounted on the roof of a trailer. The reason is because if it was mounted on the side it would most likely leak water.

view full answer...

Answer 7

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from it,…

view full answer...

Answer 8

The 12V wire at the vehicle-end trailer connector being hot even when the truck is off can vary depending on the application. For all aftermarket hardwiring installations of a 7-Way wiring harness, the 12V wire will be hot at all times, even when the…

view full answer...

Answer 9

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that will…

view full answer...

Answer 10

Changing the polarity of the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K would likely burn out the circuit board. The #MA00-06401K is designed to move air out of your trailer when the vent cover is open or pull air in and circulate the air…

view full answer...

Answer 11

Our customers have told us that the #LG-119226 Replacement Crank Handle works with most Atwood landing gear. I've linked to a product description video featuring the replacement handle. I've also provided a close-up photo showing what the end…

view full answer...

Answer 12

The original Atwood manual crank you are looking for is no longer available but we have the Replacement Crank Handle for Stromberg Carlson Landing Gear #LG-119226 that will work for your Atwood Electric Jack. This is a much longer option which would…

view full answer...

Will the Single-Bottle Liquid Propane Gas Rack 2020-JR Fit a 30 Lb Propane Tank

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching