Can the Bulldog Collar-Lok Coupler Be Used With An Anderson Weight Distribution Hitch

Question

Question:

Will this work with an Anderson WDH? I know the Anderson has to be locked in and the ball shouldnt rotate.

asked by: Richard B

0

Expert Reply:

There is no reason that you should not be able to use the Bulldog Collar-Lok Coupler part # BD028386 with your Anderson Weight Distribution Hitch. I am not very familiar with the Anderson Weight Distribution Hitch as this is not a product we offer but I did some research on it and do not see anything that would negate use with the Bulldog Collar-Lok Coupler.

expert reply by: Conner L

0

Answer 1

There is likely some corrosion inside the lock that is preventing the mechanism from working properly. You can get some spray lubricant and spray it in the lock through the key hole and let it soak for 15 minutes and try again. If this does not work…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Can the Bulldog Collar-Lok Coupler Be Used With An Anderson Weight Distribution Hitch

Product Page this Question was Asked From

Continue Researching