Troubleshooting Trailer Running Lights Not Functioning
Question:
Our running lights on camper trailer do not come on, however the brake lights and turn signals do.
asked by: Gary
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Search Results: wiring harness
- Search Results: wishbone 4 way trailer wiring harness
- Q&A: LED Bulbs Added to Trailer Clearance Lamps Not Functioning
- Q&A: Wiring a Side Marker Light to the Running Light Wire on a Trailer
- Shop: Trailer Wiring
- Shop: LED Combination Trailer Tail Lights - Submersible - Driver and Passenger Side - 25' Wire Harness
- Shop: Hook Probe Circuit Tester
- Shop: Hopkins Endurance Easy-Pull Y-Harness with 4-Pole Flat Trailer Connector - Trailer End - 20'
- Shop: Hopkins Endurance 4-Way Flat Trailer Wiring Harness - 30' Long
- Shop: Optronics Trailer Light Kit for Trailers over 80" Wide - Submersible - 25' Wiring Harness
- Shop: Mighty Cord 4-Way Flat Trailer Connector - Wishbone Style - Trailer End - 25' Long
- Shop: 25 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 25' Ground
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Trailer Hitch
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Search Results: 68149
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Search Results: 25580
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Fifth Wheel Hitch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Lippert Solera Slider Slide-Topper Review
- Article: Brake Controller Installation: Starting from Scratch