Remote Control Replacement for Come Up Winch-Seal Gen2 9.5rs

Question

Question:

I lost my remote for this wench. Can you tell me which remote control I need to purchase that is compatible? Thanks

asked by: Robert F

0

Expert Reply:

The replacement remote you need for your ComeUp Seal Gen2 Off-Road Winch # CU295955 is the Replacement Wireless Remote part # CU881102.

expert reply by: Jameson C

0

Answer 1

The battery type of the Remote part #CU881102 is a CR2032 litihium 3 volt.

view full answer...

Answer 2

The closest option we have that covers everything is the part #A16RGBML which a black wheel with an 8 on 6-1/2 inch bolt pattern and weight capacity of 4,400 lb capacity and a 14 ply rating.

view full answer...

Answer 3

You cannot really go by miles when determining when brakes should be replaced. You would know to replace them the same way you would know with a vehicle. If performance is suffering and adjusting the brakes does not help and there are no other issues…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Remote Control Replacement for Come Up Winch-Seal Gen2 9.5rs

Products Referenced in This Question

Continue Researching