Installing Load Resistors on GMC Savana to Prevent Hyperflashing with New LED Lights
Question:
2007 GMC Savana hyperflashing turn signals I have installed replacement LED bulbs for the turn signals and reverse lights, but I cannot find a correct combination of wires for the load resistor to prevent the hyperflashing. Either the connectors are not getting through to the wire properly, or there may be something else going on. What is the wiring diagram for the turn signals, front and back, for this vehicle? I cannot find a copy online at all. ANy other suggestions for troubleshooting would be appreciated There is a trailer hitch installed and it appears that was wired into the wiring going to the right side tail light.
asked by: David
Expert Reply:
Installing some load resistors like the Diamond # DI34ZR to the circuits mentioned should resolve the hyperflashing you are getting with the new LEDs. When installing the resistors you want to make sure that you connect them in line with the turn signal circuit wire before the bulb and not after.
I wasn't able to track down the specific wire colors of these circuits on your Savana so the best route will be to use a circuit tester like # PTW2979 to test the wiring behind the tail lights. Have somebody run through the turn signals while you look for the wire that gets power when they are on.
I have attached a diagram for the load resistors that you might find helpful as well.
Products Referenced in This Question
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Shop: Vehicle Lights
- Search Results: load resister
- Search Results: load resistor
- Q&A: How Many Load Resistors Are Needed When Installing LED Turn Signal Bulbs on 1993 Silverado
- Q&A: Are There LED Lights With Built In Resistors Available
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class IV - 2"
- Shop: Buyers Products 2" Hitch Receiver For GM Express/Savana
- Shop: Trailer Wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Replacement OEM Tow Package Wiring Harness with 4-Pole Flat Trailer Connector - Chevy/GMC Vans
- Shop: Universal Wiring Adapter for Curt Trailer Brake Controllers
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: etrailer.com Trailer Hitch Installation - 2013 Chevrolet Express Van
- Video: Trailer Wiring Harness Installation - 2003 GMC Savana Van
- Q&A: 4-Way Trailer Wiring Harness For 1999 Chevy Express Van
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Adding Brakes to a Mobile Home Axle
- Search Results: 68149
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Search Results: 25580
- Article: Trailer Wiring Diagrams
- Shop: Suspension Enhancement