Recommended Side Mirrors for a 1991 Fleetwood Tioga Arrow Motorhome

Question

Question:

looking for driver and passenger side mirrors for a 1991 ford tioga arrow 28

asked by: Jack

0

Expert Reply:

The best option I have for you to add side mirrors to your 1991 Fleetwood Tioga Arrow is going to be with the CIPA Universal Door-Mount Replacement Mirrors part # CM45000-2 which will provide you with an excellent view of your motorhome and they are pretty easy to install as well. The mirror faces are fully adjustable and the cushioned rubber trim that outlines each mirror face will work to reduce vibrations. The hardware that you need for installation is included.

expert reply by: Conner L

0

Mick

5/11/2020

Can you give me the bolt pattern dimensions of this product? I need to replace the existing similar mirrors.

Reply

Chris R.

5/14/2020

The mounting holes for the CIPA Universal Door-Mount Mirrors # CM45000-2 are spaced apart by 3-13/16". I linked an expert answer below that also shows a couple other dimensions.

Helpful Links

question-395800.html

Reply

Answer 1

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won&#39;t extend or retract even with the motor running. It&#39;s possible that it may have been over-extended or something internally has…

view full answer...

Answer 2

While we do not carry that particular Lippert step we do have the similar MORryde #MR98RR or a better option in my opinion is the TorkLift GlowStep #TLA9104. I prefer this step as it folds up nicely and works better in tight areas like storage…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 4

The top mounting hole measured center to center to the bottom mounting hole is 18". The overall length of the arm is 19 1/4". The mirrors are going to be a bolt on installation, it may require drilling if existing holes are not…

view full answer...

Answer 5

I pulled the CIPA Deluxe Door Mount Mirror, #11650, as well the CIPA Round, Convex HotSpot Mirror, #CM48500, from our warehouse in order to perform a quick test fit for you. In my test fit I placed the bracket for the hotspot mirror on top of the…

view full answer...

Answer 6

The bolt holes on the top bracket of the CIPA Universal Door-Mount Replacement Mirrors #CM45000-2 are 3-13/16" apart center to center. I have attached a few diagrams showing the measurements for your reference.

view full answer...

Answer 7

I recommend checking out the CIPA Universal Door-Mount Replacement Mirrors #CM45000-2 for your 1995 Ford L-Series truck. These bolt onto the door and give you a mirror that is 7-1/2" wide x 10-1/2" tall. These are a perfect solution…

view full answer...

Answer 8

The distance between the lower arms on the K Source Universal Low-Mount Style Door Mirror #KS29MD runs 8-10" for installation. K Source was unable to give me the length and width of the mounting plate but the distance between the mounting…

view full answer...

Answer 9

My contact at Optronics confirmed that the output candle power of Optronics Flush-Mount Clear LED Trailer Backup Light #BUL35CB is 1120 per lamp. This trailer light uses a tiny amount of power since it features high-efficiency LEDs instead of…

view full answer...

Answer 10

I may have a solution for you, but we do not have a custom mirror available for the 1982 E-350. You might be able to make the CIPA #CM45000-2 work for you, but it would be the best solution we have available. I've linked some photos that…

view full answer...

Recommended Side Mirrors for a 1991 Fleetwood Tioga Arrow Motorhome

Product Page this Question was Asked From

Continue Researching