Does Titan Hydraulic Brake Kit # T4489600-500 Come with Hubs/Drums

Question

Question:

Does the drum come with the brake assy.

asked by: HDWheeler

1

Helpful Expert Reply:

The Titan Hydraulic Brake Kit # T4489600-500 that you referenced does not come with hub/drums.

Since this is a 6k axle brake kit the correct hub/drum you'd need is the Dexter part # 8-201-9UC3-EZ which would fit the same spindle as what the Titan brake kit you mentioned would have been designed for.

expert reply by: Jameson C

1

Answer 1

I have attached an image from the operation manual for the Demco Hydraulic Brake Actuator #DM8669112 that details how to bleed the brakes. The process consists of first elevating the trailer tongue about 4 to 6 inches and then loosening or removing…

view full answer...

Answer 2

We do have the replacement rubber trivet support bumpers for the Furrion stove #FGH4ZSASS that you referenced as part #CFGH4ZSASSTRIVETSPRT.

view full answer...

Answer 3

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 4

In order to charge your batteries wired in parallel with the NoCo Genius #329-GENIUS5 you'll want to connect the positive charge line to the positive terminal of the first battery and the negative line to the negative terminal of the opposite…

view full answer...

Answer 5

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 6

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain…

view full answer...

Answer 7

The 4-bolt brake mounting pattern is fairly rare in a 12 x 2 inch assembly. We have some options though; for 6K axles we have #23-105-09 for the left and #23-106-09 for the right. The 4-bolt pattern on these assemblies is offset meaning the bottom 2…

view full answer...

Answer 8

I can tell you were to access the correct brake switch wire to install a brake controller on your 2014 GMC Savana Van. You will need to access the wire behind the BCM (body control module) located behind the dash on the passenger's side of the…

view full answer...

Answer 9

The four bolt brake mounting flange for 8,000 lb trailer axles is going to be more or less an industry standard. This industry standard is 3-5/8" across left to right on center and 3-7/16" top to bottom on center. This could very well vary…

view full answer...

Does Titan Hydraulic Brake Kit # T4489600-500 Come with Hubs/Drums

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching