Attaching Solera Awning Plain Idler Head Front Cover

Question

Question:

Not sure how cover attaches to back cover

asked by: Kevin P

0

Expert Reply:

To attach the Solera Awning Plain Idler Head Front Cover # LC289566 to the Solera Awning Plain Idler Head Back Cover # LC289567 you will need to use your original hardware. The two covers will fit together and you can simply screw them in using the hardware you have of the cover you are replacing.

expert reply by: Kyle S

0

Answer 1

For the Replacement Cover for Solera Awnings #LC643923 for the idler head, and the Replacement Cover for Solera Awnings #LC643922 for the drive head, you can use the: -Replacement Solera Manual Awning Head Cover Fastener #LC266156, which are #6 x…

view full answer...

Answer 2

A standard Phillips head screw would be all that you'd need to remove the cover of the Solera Power Awning Idler head.

view full answer...

Answer 3

Zinc plated screws are going to be the best option for use with aluminum to resist galvanic corrosion. This corrosion you are referring to is from two dissimilar metals reacting so you want to use the most similar metals when installing your E-track…

view full answer...

Answer 4

There isn't one set in stone way to install the RC Manufacturing T-Series Trailer Tongue Toolbox #350980 but typically people will drill holes through the bottom of the box and into the trailer frame below it and then run carriage bolts through…

view full answer...

Answer 5

While I do not have a video demonstrating how to install or remove the idler head and drive head cover for the Lippert Edge Awnings, it is a pretty simple process. You will need to extend the awning out far enough to get access to behind the cover,…

view full answer...

Answer 6

We actually do have 1 Lippert hydraulic jack with a 7-hole mounting bracket. - Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC36VR According to Lippert, the Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC36VR…

view full answer...

Answer 7

To remove the front cover #LC643923 from your Solera Awning there are indeed 2 screws that need to be removed. If you look at the back f the idler head unit you can see the locations where the screws reside that you need to remove. I have attached a…

view full answer...

Answer 8

The standard torque on a Redline Trailer Wheel Lug Nut - 9/16 inch, part #6-53, is 135 to 145 ft lbs. This is the torque range that is normally used. If the instructions for the wheel are saying 110 ft lbs there might be a reason, like the wheel…

view full answer...

Answer 9

The Roadmaster base plate kits are designed to be used with the Roadmaster tow bar part #RM-501 that you referenced. I believe you have a 2017 Jeep Wrangler so for that the easiest solution is the #RM-521448-4 which I attached an install video for.

view full answer...

Answer 10

The Replacement Actuator for Thomas Payne Seismic Power Recliner #SC96MR is the correct replacement actuator for your eMoMo model 3MTR135-334A. This actuator fits all Thomas Payne Seismic power recliners. I attached a review video link below.

view full answer...