Receiver Position for Curt Front Mount Trailer Hitch on a 2008 Jeep Grand Cherokee  

I have attached a picture of the CURT Front Mount Trailer Hitch Receiver, #C31047, installed on a Jeep Grand Cherokee. The hitch does not install all the way below the air dam. The air dam will actually be removed and then reinstalled after hitch…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

For your 2007 Ram 3/4 ton, I'd recommend the Curt #C31017 which would mount to the underside of the frame members and would have the receiver tube sitting directly under the front bumper. I spoke with my contact at Draw-Tite who confirms that…

The Curt A16 5th Wheel Trailer Hitch w/ R16 Slider #C16521 that you believe you have can be adjusted from 17-1/2" - 21-1/2" in regards to height. If you were to swap out the R16 Slider for the Replacement Base Legs #C16920 then this would…

From what I was able to find, the Warn M12000 winch is 24.37" L. x 8.45" D. x 11" H. I've attached a picture with the dimensions on the Bulldog Winch Hitch Mounted Winch Plate #BDW20011 but since the mounting cradle is only…

The RV Kitchen Faucet w/ Pull Down Spout & Single Lever Handle, #277-000409 has a button on the spout that is for changing the water flow between the options of either a spray of a stream. The on/off for water flow itself is the lever on the main…

We've actually had this one asked before and have consulted with MaxxAir. Even though you can technically install the MaxxFan Deluxe Roof Vent #MA00-06401K wired to a separate switch, it is not recommended. The reason for this is that their fans…

The only front mount hitch for the 2008 Jeep Grand Cherokee is Curt Front Mount Trailer Hitch Receiver - Custom Fit part #C31047 which is designed to sit below the bumper. We currently do not have a front mount hitch for the Jeep Grand Cherokee that…

When we installed the Curt hitch part #13414 on a similar Jeep Commander as your 2006 model we found that from the center of the hitch pin out to the furthest point out on the rear bumper the measurement is 3-1/2 inches. In case you were asking about…