Compatible Jensen Antenna For JWM60A Jensen Stereo

Question

Question:

I have Jensen JWM6a stereo in my motorhome that has an unused +12 VDC 100ma Amp remote feed wire. Since it is a switched feed wire it would work perferct for feeding this antenna if 100ma is enough power. Unfortunately I have been unable to find any power requirement specs for this antenna. Hopefully you can provide me with the answer as to what the power requirements are.

asked by: Sherman

0

Expert Reply:

I contacted Jensen and the Jensen Amplified Antenna part # AN150SR is compatible with the Jensen Stereo part # JWM60A plug. They were not able to tell me the power draw of the antenna itself. All of the Jensen Antenna we carry are compatible with the plug on the JWM60A stereo.

expert reply by: Heather A

0

Answer 1

After looking up the wiring diagrams for your old RV Stereo AWM970 and your new Jensen RV Stereo #JWM60A (Jensen part number JWM62A) you new stereo should actually have 3 more wires, not less wires. The AWM970 had two connectors, a 12 pin and a 4…

view full answer...

Answer 2

The "Amp Remote" blue wire coming from the harness for your Jensen RV Stereo #JWM60A is only used if you are needing to power an external amp. If you have an external amp you would would run this wire to it, which basically tells…

view full answer...

Answer 3

Yes, I found the owner's manual for the Jensen JWM40 stereo System and there is a plug for the antenna part #AN150SR. I confirmed with Jensen that all of their antennas are compatible with all of their stereo units.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Compatible Jensen Antenna For JWM60A Jensen Stereo

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching