Aluminum Roof Vent with Interior Plastic Piece

Question

Question:

I have seen these type of vents used with a plastic piece that reinforces the other side of the aluminum. Do you sell these or know where to get them?

asked by: Kevin T

0

Expert Reply:

The closest vent assembly we have to what you described is the Redline 2-Way Pop-Up Roof Vent # RV-626-062-2756. This aluminum vent includes a black plastic inner garnish that's going to help hold the vent in place while also allowing for a nice clean look inside the trailer. The vent can open in 2 directions to help with air flow regardless of which direction the wind is blowing outside.

This will fit a rough opening size of 11-1/8 inches long and 5-1/2 inches wide. Its overall dimensions are 13-3/8 inches long, 7-3/4 inches wide, and 3-1/2 inches tall. I have attached a short video review that you can check out as well.

expert reply by: Chris R

0

Answer 1

I've attached pictures showing the pretty much every dimension of the Replacement Exterior Pop-Up Roof Vent #RV-626-062. If you need any other measurements please reply back and I'll get them for you.

view full answer...

Answer 2

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other 4" wide to fit different size bumpers: - Pre-Drilled…

view full answer...

Answer 3

Hey Tim, thanks for the picture of your current brake assemblies. While what you have doesn't look exactly like a free-backing setup you definitely can replace what you have with them. For that I would go with the etrailer part #AKFBBRK-35 which…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Based on the information you provided either the Titan Hydraulic Brake Kit - Free Backing - 10" - Left and Right Hand Assemblies - 3,750 lbs #T4071600-500 or #T4423500-400 will fit your drums. The only difference between these two brakes is the…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

I checked with Erickson and their Removable Motorcycle Wheel Chock item #EM07506 does not have a weight rating. It is made of steel and works with bikes that have up to 6" tires. So long as your Honda and Kawasaki do not have wider tires this…

view full answer...

Answer 8

The Firestone Heavy Duty Air Compressor item #F9499 can be mounted in any position or orientation. Firestone recommends it be installed on the frame rail of your 2016 Toyota Tundra. There is no specific spot the compressor is supposed to be…

view full answer...

Answer 9

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 10

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Aluminum Roof Vent with Interior Plastic Piece

Product Page this Question was Asked From

Continue Researching