Does Adjusting B&W Patriot 5th Wheel Hitch Affect Towing Performance on 2018 Chevy Silverado 2500

Question

Question:

Thinking about purchasing this hitch - how do you determine the amount of set back for the hitch - it says it can be 0 - 2 or 4 inches. Is it just personal preference and does it have any effect on towing characteristics? It would be going on a 2018 Chevy 2500HD.

asked by: Scott N

1

Helpful Expert Reply:

You have made a good decision thinking about using the B&W Patriot 5th Wheel Trailer Hitch # BWRVK3255 on your 2018 Chevy Silverado 2500 and the ability to adjust it front-to-back will not affect its towing characteristics.

This hitch adjusts to give you optimal positioning to make turns, and there is actually a formula you can use to help you determine if you can make a full 90 degree turn, which you an see below. It is recommended that you have at least 4 inches of clearance in order to make a full 90 degree turn.

(A + B) - C = Clearance
A = Distance from the fifth wheel jaw center to the truck cab
B = Offset used (slider clearance or Sidewinder offset)
C = Width of the nose of the trailer divided by 2

In this formula if you adjusted the Patriot fore or aft, "A" would be affected by up to 4 inches ("B" would be zero unless you are using a Sidewinder because this is a fixed hitch).

Overall, the B&W Patriot # BWRVK3255 is going to give you an improved ride over other fifth wheel hitches because of its powerful dual jaws which are 3/4" thick and wrap totally around your king pin, meaning there will be less back and forth movement of the king pin in these jaws than other hitches with inferior jaw systems. It also has cushioned bushings to minimize the noise often experienced with fifth wheel towing, is made in the USA and comes with a lifetime warranty, which speaks to its durability.

To install the Patriot in your '18 Silverado 2500 I recommend the B&W Custom Installation Kit w/ Base Rails # BWRVK2506 because it will not require drilling in the frame of your Chevy to install, which is good for your truck and will cut the installation time down significantly.

If you need a fifth wheel wiring harness I recommend the 5th Wheel/Gooseneck Wiring Harness 7-Pole # 50-97-410.

I have added links to video reviews of these products for you to check out as well.

expert reply by: Kyle S

1

click to enlarge

Answer 1

If you are installing the B&W Patriot #BWRVK3200 in your 2015 Ford F-250 Super Duty using industry-standard rails such as #BWRVK2401 then you would only need standard, 3-1/4" long, 1/2" diameter pins such as #6014.…

view full answer...

Answer 2

Yes, the B&W Custom Installation Kit w/ Base Rails item #BWRVK2506 are compatible with Reese sliding 5th wheel hitches. This custom kit is confirmed to fit your 2019 Chevy Silverado 2500. It will supply you with a set of industry standard…

view full answer...

Answer 3

The only difference between the two lube plates is the color and their thickness. The #RP83004 is black in color, and is 1/8 of an inch, or .125 thick. The #RP83001 is white in color, and is a bit thicker at .192 of an inch, or just below 1/4 inch…

view full answer...

Answer 4

You'll actually want to measure from the ground to the floor of the bed and not the top of the sides. The height I'm seeing from an open tailgate (floor of the bed) to the ground for a 2021 Ford F-250 Super Duty is approximately…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 6

When adjusting the height of a pin box such as #LC1191191 it is important to support the pin box when removing the bolts. I recommend 2 or 3 buddies to give you a hand and make sure no one is beneath the pin box while raising or lowering it. With…

view full answer...

Answer 7

To install the Tekonsha Prodigy P3 Electric Brake Controller #90195 into your 2014 Chevrolet Express the black wire from the controller will go to 12 volt power, the blue wire runs back to your 7-way trailer connector at the rear of your van, the…

view full answer...

Answer 8

I can tell you were to access the correct brake switch wire to install a brake controller on your 2014 GMC Savana Van. You will need to access the wire behind the BCM (body control module) located behind the dash on the passenger's side of…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes you are - all 5th wheel hitches are going to require some type of rails in order to be used. So you'd need #DM8552016-71 for your 2006 Dodge Ram.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

While we do not have an install video for the Curt Custom Fifth Wheel Installation Kit #C93BR we do have another install video which will be very similar as it uses a different Curt rail kit on a 2014 Chevrolet Silverado 3500. This video is attached…

view full answer...

Does Adjusting B&W Patriot 5th Wheel Hitch Affect Towing Performance on 2018 Chevy Silverado 2500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching