Can Redarc Smart Start Battery Isolator # 331-SBI212D pass 200 Amps to Deep Cycle Battery

Question

Question:

I need an isolator that will run from my 12v 220amp vehicle alternator and pass through 200amps to my 12v lifepo4 deep cycle battery bank.

asked by: Shawn S

0

Expert Reply:

The Redarc Smart Start Battery Isolator # 331-SBI212D that you referenced would work well for you since you need to pull 200 amps through it from your starter battery. I attached a diagram that shows how this wires to your setup as well. This has a max continous current of 200 amps and can be used with LiFePO4 batteries.

expert reply by: Jameson C

0

click to enlarge

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

When wiring up the Deka Battery Isolator #DW08771 the main/first battery will connect directly to position one on the isolator without the need for a circuit breaker. The second battery though should be attached to the second position on the isolator…

view full answer...

Answer 3

You can use the solar panel charge kit #34272628 with the battery bank of your camper and still charge the batteries with a separate charge source (vehicle alternator, power outlet) but you'll also want the Redarc #331-SBI212D which balances the…

view full answer...

Answer 4

Your Greystone WF2613R fireplace has actually been discontinued, and its replacement parts are no longer available, unfortunately. I know it's not what you're wanting to do, however since your fireplace and its parts are no longer available,…

view full answer...

Answer 5

Yes, the High Pointe Over the Range RV Microwave #HP74ZR has a two speed exhaust fan which will remove all smoke, steam, and odors out of the immediate cooking area, but it will not vent it outside. If you wanted to have the microwave be able to vent…

view full answer...

Answer 6

In regards to battery isolators, they should be rated at or close to the changing amperage rating of your alternator. They don't really need to exceed this as it's very unlikely your alternator will ever reach its max charging amperage. I…

view full answer...

Answer 7

The Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers #325-GH-1324 that you referenced doesn't have the same features as weight distribution or sway control so it's hard to compare them. It will cushion the ride quality when you are towing but…

view full answer...

Answer 8

Yes. You can use your existing weight distribution hitch with the Gen-Y Torsion 2 Ball Mount #325-GH-1324 without any additional components, but it is not the optimal setup. Gen-Y recommends that you use the Gen-Y Torsion Weight Distribution Shank -…

view full answer...

Answer 9

I spoke with my contact at Redarc regarding the Smart Start Battery Isolator #331-SBI212D referenced in your question. He stated that with the override, you will want a 200 amp fuse. Without the override you can use a 120 amp fuse. Also note that the…

view full answer...

Answer 10

I would be happy to answer your questions. First off charging between the house and chassis batteries does not go through the power center you are correct. To answer your second question I reached out to Progressive Dynamics over the weekend and just…

view full answer...

Can Redarc Smart Start Battery Isolator # 331-SBI212D pass 200 Amps to Deep Cycle Battery

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching