bing tracking image
Q & A Icon

Upgrading Lights on 2000 Tracker PT175 Trailer to LED  

Question:

Jon, attached are the pictures that you requested. The top pictures are the front side markers and they have a Wes Bar # 3395. The other side markers with the posts/nuts and attached wiring do not have any part #’s and they measure 2 1/8 x 1 1/8. The passenger side rear light has a Wes Bar # 102641. I will also need any required pigtails etc. thanks Jon for the assistance.

1

Helpful Expert Reply:

We do offer a wide variety of replacement lights for trailer but since trailer manufacturers don't keep a record of what they use on trailers I would need some pictures of the lights you are wanting to replace along with some measurements so I can be sure to recommend the correct parts.

expert reply by:
1
Jon G
click to enlarge
click to enlarge
click to enlarge
click to enlarge

Ernest

4/30/2019

Jon, attached are the pictures that you requested. The top pictures are the front side markers and they have a Wes Bar # 3395. The other side markers with the posts/nuts and attached wiring do not have any part #’s and they measure 2 1/8 x 1 1/8. The passenger side rear light has a Wes Bar # 102641. I will also need any required pigtails etc. thanks Jon for the assistance.

Jon G.

4/30/2019

Thank you for the pictures and the descriptions! For your Wesbar 3395 clearance lights you can use the Thinline LED Clearance and Side Marker Light # AL91AB. This is compatible with the Wesbar 108662 pigtail that I believe you are already using so this will be a simple plug and play application. For the other clearance lights we have the Optronics LED Clearance or Side Marker Light # MCL95AB that matches right up with the dimensions that you gave. This light has 1 wire and it grounds through the mounting hardware as opposed to your light that has a wire for power and a wire for ground. Then for your tail lights you can use the Optronics LED Combination Trailer Tail Lights # TLL160RK. These have the same dimensions as your current tail lights and it has a 3-wire design like your lights have. You should be able to cut the connectors off of your old tail lights and then splice them onto the new LED tail lights using Heat Shrink Butt Connectors # DW05744-5.

Products Referenced in This Question




Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>