Are Brackets for CargoSmart Cabinet Available Individually

Question

Question:

Im looking to make some custom brackets that mount to e track. This cabinet looks to come with bolt on E track connectors. Is it possible to buy just these bolt on connectors?

asked by: Justin D

1

Helpful Expert Reply:

We likely have some parts that can help you in regard to custom brackets, but the brackets from the CargoSmart Locking Cabinet for E-Track or X-Track Systems # 3481725 are not something that can be purchased separately.

I recommend taking a look at a few different options: CargoSmart Shelf Track Brackets for E-Track or X-Track Systems # 3481726 or the same brackets, which are folding, part # 3481727; there are also the CargoSmart Dual Track Brackets for E-Track or X-Track Systems # 3481728.

The other part you may want to look at are the CargoSmart Board Holder for E-Track and X-Track Systems # 348892.

expert reply by: Kyle S

1

Answer 1

I looked through all of our available manual A-Frame trailer jacks and the option with the shortest retracted bracket height is the etrailer.com A-Frame #TJA-2001-B. The retracted bracket height is right at 5-1/8 inches from the ground and it has a…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Are Brackets for CargoSmart Cabinet Available Individually

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching