Does a Breakaway System Need To Have Its Own Battery

Question

Question:

i have switch wired in to my battery on my trailer not a seppert batt. will this work?

asked by: Charles J

0

Expert Reply:

The breakaway system actually must be attached to its own separate battery by law in most states. Therefore, I cannot recommend that you use a seperate, auxiliary battery on the trailer or the vehicle for that matter for the breakaway switch. The most cost effective breakaway system we have for you is the Curt Soft Trac II Trailer Breakaway Kit part # C52026.

I have attached a photo for you to show how it will need to be wired.

expert reply by: Conner L

0

click to enlarge

Answer 1

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 2

To wire in the Trailer Breakaway Kit Battery Charger #20011 you'd run the black wire to the 12 volt accessory circuit of the trailer wiring, the red wire to the battery in the breakaway switch and the blue wire breakaway switch. The 12 volt…

view full answer...

Answer 3

There is not a breakaway kit battery charger, including the Hopkins #20011 that will eliminate vampire draw completely. I do strongly recommend taking a look at the help article I added on trailer breakaway kit installation. Going by this should…

view full answer...

Answer 4

Most hubs that fit a 2,000 lb axle can only fit up to a 12 inch diameter wheel. What size wheels/tires do you have now? There might be a larger size available but probably only up to a 12 inch wheel setup. We don't have them pre-mounted so…

view full answer...

Answer 5

If all you want is to prevent the 12 volt power supply of your trailer battery wiring from backfeeding onto your vehicle wiring or vice versa what you need is a one-way diode like part #RM-690. This only allows current to flow in one direction so…

view full answer...

Answer 6

To charge a battery for use in your trailer you will need to either use the CTEK MULTI US 7002 12-Volt Universal Battery Charger w/ Pulse Maintenance #CTEK56353 when you have your trailer parked, or use the Dual Battery Charger #331-BCDC1240D. The…

view full answer...

Answer 7

If you installed a decently sized deep cycle battery on your trailer you wouldn't have a problem powering the LED lights of it for the length of time mentioned since LED lights draw a fraction of the amperage as incandescent. Group 24, 27, and 31…

view full answer...

Answer 8

There is not a minimum or maximum width but you're generally going to want at least 1". Because the tires don't turn, you're not really restricted and may be able to get away with slightly less, but generally 1" is going to…

view full answer...

Answer 9

A breakaway kit can be wired in one of two ways to the trailer brake system. The first way would be to use the Engager Trailer BreakAway Kit with Charger and Tester, item #20099 , and splice off of the power wire that maintains the trailer's…

view full answer...

Answer 10

A trailer wheel measuring 15" in diameter by 4.5" wide is a rather uncommon wheel size as most 15" diameter trailer wheels are either 5" or 6" wide. Unfortunately we do not have a tire suitable for your 15" x 4.5"…

view full answer...

Answer 11

If you didn't have a battery used with your breakaway system there'd be nothing to power the brakes in the event of a disconnect so you couldn't use just a switch like the part #FA80-00-2040 by itself. You'd instead need to use a…

view full answer...

Answer 12

The easiest way to figure out if the fan is 12v or 120v is to try to turn the fan on while you aren't hooked up to shore power. If it turns on without being hooked up to shore power or a generator, then it is a 12 volt fan. According to all of…

view full answer...

Does a Breakaway System Need To Have Its Own Battery

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching