Mounting Pad Dimensions of K-Source Backup Mirror # KSC088

Question

Question:

Hi there, What are the dimensions of the mounting pad?

asked by: Tyler B

1

Helpful Expert Reply:

I attached a picture that has all of the mounting pad dimensions of the K-Source Backup Mirror # KSC088. Basically it's 2-7/8 inches wide and 4-3/4 inches long.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The #KSC088 K-Source backup mirror would work for aligning your fifth-wheel hitch and king pin, but this mirror will only allow you to see a field up to 6' behind the mirror. If your truck has a long bed, you would not be able to see the king pin…

view full answer...

Answer 2

The K-Source Stick-On Backup Mirror #KSC088 is really meant to install on the smooth glass surface of a vehicle's rear window. The painted steel surface of a 5th wheel pin box might not be quite smooth enough to provide for safe installation. You…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Mounting Pad Dimensions of K-Source Backup Mirror # KSC088

Product Page this Question was Asked From

Continue Researching