Does Rear View Safety Backup Sensors part # RVS-115 Require Bumper Drilling
Question:
I HAVE A 2018 f150 WITH FACTORY BACKUP CAMERA, BUT NO BUMPER SENSORS. does this kit require drilling the bumper? How does it get tied to the vehicle system, if at all thanks as usual
asked by: James H
0
Expert Reply:
You will need to drill 4 holes in the rear bumper of your 2018 Ford F-150 to install the Rear View Safety Backup Sensors part # RVS-115. You'll want to drill them at equal distances in the rear bumper. The holes will need to be 21.5 mm when not using the grommets or 25 mm when using the grommets.
This does not tie into the wiring of your vehicle aside from power and ground.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rear View Safety Backup Sensor System
- Backup Camera
- Alerts and Sensors
- Hardwired
- Rear View Safety
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed to Flat Tow 2022 Ford Bronco Badlands
- Q&A: Can Blue Ox Patriot Braking System be Used with 2023 Ford Bronco
- Q&A: Replacement RV Entry Door Lock That's Tall and Skinny
- Q&A: Will SumoSprings Lift the Front End of a 2017 Ford F-350
- Q&A: Recommended Trailer Connector And Wiring Harness For 2014 Jeep Wrangler Unlimited With Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Will Hopkins License Bracket Mount Backup Sensor System # HM60100VA Fit 2014 Ford F-150
- Q&A: Blind Spot System Fit for a 2022 Ram 1500
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best Bike Racks for Electric Bikes
- Article: Ram Trailer Tow Prep Package
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV