Replacement Lippert 4 Point Control Panel for 2007 Damon Outlaw Motorhome

Question

Question:

do you have a crossover number for #175225 and matching pigtail? I need a new panel and matching pigtail. thanks.

asked by: Robert M

0

Expert Reply:

It sounds you are looking for the Lippert 4 Point Control Panel W/ Amp Connector part # LC175225. The correct wiring harness to use with this control panel is the Replacement Lippert Components 4-Point Leveling System Control Brain Wiring Harness part # LC178278. I confirmed all of this with my contact at Lippert.

expert reply by: Conner L

0

Troy C.

3/8/2020

I just replaced my LC175225 Lippert panel but all the lights down the left side are flashing and the unit will not do anything. Please advise. Thanks

Reply

Chris R.

3/10/2020

I would try disconnecting 12V power from the main control panel and leaving it unhooked for at least 15 minutes. Then try hooking it back up to power to see if this resolves the issue. The unit may just need to be reset after replacing the panel. If this doesn't help please let me know about how old your 4-Point system is and we can go from there!

Reply

Answer 1

The auxiliary or back-up wire on a 7-way trailer connector like #HM20041, is used to power to things like interior trailer lights or other 12V accessories. It can also be used to power backup lights, but not many trailers are equipped with those.…

view full answer...

Answer 2

I was able to do some digging and found out that Sure-Trac trailers use either a Dexter or Lippert axle, and both of these 3,500 lb axles use the same bearings and grease seal, so we have exactly what you need. The Bearing Kit for #84 Spindle…

view full answer...

Answer 3

It sounds like the wiring was changed going into the solenoids at the hydraulic pump on your 2007 Damon Daybreak. I would check these connectors as it sounds like they were mixed up if the unit was swapped out. This would explain why your jack…

view full answer...

Answer 4

More than likely the issue is going to be the control panel. There are a couple of things you can try before replacing your current panel though. The first thing you can do is to make sure that all of the connections on the back are solid and then…

view full answer...

Answer 5

We do have a replacement wireless remote for the Lippert Ground Control 3.0 #LC358590, for that you would want the part #LC358601. Here is how the remote would get programmed: 1. Enter the Leveler app on the LINC Remote. 2. Turn the remote on by…

view full answer...

Answer 6

It appears that all you going to need is the Replacement Lippert 4-Point Leveling System Control Brain Wiring Harness #LC178278. This wiring harness will allow you to plug your new Replacement Lippert Leveling Control Brain for 4-Point Leveling…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Replacement Lippert 4 Point Control Panel for 2007 Damon Outlaw Motorhome

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching