Trailer Hub Seal Recommendation for Hub with Race LM11910

Question

Question:

The spindle is one an one sixteenth of and inch the lm 11910 is the hub race I need a axel seal number

asked by: Joe T

0

Expert Reply:

The race number you mentioned isn't a very commonly seen race but it is used on an agricultural hub like the part # AH15450ECOMP which does use the seal you referenced of # SL150.

expert reply by: Jameson C

0

Answer 1

Here is a list of the Agricultural Spindles we currently carry. Spindle #TRU34FR Spindle #TRU54FR Spindle #TRU67FR We also have the #42 Spindle #TRU57FR which has the 2.25" that may be what you are needing. This is a very common size that may…

view full answer...

Answer 2

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 3

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 4

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Answer 5

Due to the fact that carbon fiber bikes have a more sensitive frame, Thule does recommend using the Thule UpRide #TH599000. Bike rack technology has not changed to make the racks less compatible, but carbon fiber bikes have become increasingly…

view full answer...

Answer 6

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 7

It is really not a great idea to drive with a trailer cover like the part #052963735635 installed on a trailer. The only way I could safely recommend you do so is if you were to keep the speeds under 25 miles per hour and you weren't on a public…

view full answer...

Answer 8

There are and were numerous 2-step Kwikee electric steps available. To ensure we get you the correct replacement I would need to know the series of the steps you have. Check the underside of your steps for any model numbers or other information. The…

view full answer...

Answer 9

I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To further…

view full answer...

Answer 10

Brake magnets are made to fit their specific brake assemblies. They are not made to be interchangeable between brake sizes or weight capacities. Some manufacturers do use different color magnet wires that correspond to the capacity. We know that…

view full answer...

Answer 11

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

view full answer...

Answer 12

With an unkown axle it is hard to know what it's capacity would be. Plus a trailer's capacity is more than just the axles it uses. You have to consider the suspension, the frame, coupler, brakes etc. The part #20440I-EZ-60 that you referenced…

view full answer...

Trailer Hub Seal Recommendation for Hub with Race LM11910

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching