Replacement for J-67 Oval Trailer Taillights

Question

Question:

I have a Gatormade trailer that needs several lights replaced. They are 6inch oval J-67, 7 diode recessed lights. There is also one 2-1/2inch round 3 diode light. Which of your products will fit in the existing grommets? Thank you!

asked by: Jim

0

Expert Reply:

For an exact replacement you'd want the part # TLL12RK as I looked up the J-67 and that's exactly what these are. Trailer lights are often made by several companies to the same dimensions etc and this is an example of that.

expert reply by: Jameson C

0

Answer 1

The Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK has grommets that are 1-1/8 inches deep. The plate dimension if you want to use the integrated lip on the grommet is 3/16 inch and if not is up to 1/2 inch. I went out to our warehouse…

view full answer...

Answer 2

Did you pull any fuses or disconnect the battery before installing the Replacement Hydraulic Pump for Lippert Level Up Leveling Systems #LC58TF Vic? Have you tried unplugging and replugging the connector back in to see if a pin needed to be reseated?…

view full answer...

Answer 3

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 4

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 5

Your surge coupler will have either a sticker or an engraving on it, typically near where the coupler is located. If you can get me that information and what you're needing to replace on it I'd be more than happy to help you find what…

view full answer...

Answer 6

Past customers have told us the AL-KO 8460 uses inner bearing 25580 and outer bearing 15123, which would make the Timken Bearing Kit #TMK82VR the correct replacement bearing kit for that hub. If you are looking to replace the hub entirely the correct…

view full answer...

Answer 7

The Glo-Brite 9553 you have currently measures 6-1/2" x 2-1/4" x 2-1/4" so for an incandescent replacement option I recommend the Custer Trailer Tail Light - Submersible - Stop, Turn, Tail - Incandescent - Oval - Red Lens #G65R which…

view full answer...

Answer 8

The trailer tire and wheel combo to fit your 10K Dexter axle would be the Taskmaster Provider ST235/85R16 Trailer Tire with 16" Vesper Silver Dual Wheel, #TA45FR. This wheel can be used as either the inner or outer wheel of a dual-wheel setup.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...