Could Landing Gear Set # RVLG-8000 Install on Bumper Pull Trailer
Question:
I understand some fabrication work may be needed however is there any reason why I should not install landing gear on my 20foot Cargo-Mate bumper pull enclosed trailer?
asked by: Mark
0
Expert Reply:
There's no reason you couldn't install the Landing Gear Set # RVLG-8000 that you mentioned on your bumper pull trailer. It would take fabrication like you mentioned but it would work well once installed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Bracket Dimensions of the etrailer RV Landing Gear System # RVLG-8HDL
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Replacement Crank Handle for Ram 5th Wheel Landing Gear Compatibility With 2007 Fleetwood Nitrous TT
- Q&A: Landing Gear Replacement for Northwood Arctic Fox 27-5L 5th Wheel
- Article: Best Landing Gear
- Q&A: Troubleshooting Clicking Noise Coming From Landing Gear or Motor
- Q&A: How to Know if Landing Gear Set # RVLG-8HDL Will Fit 2001 Sunnybrook 31BWFS
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Does Solar Panel Type Really Matter?
- Article: Most Popular Wheel Bearings