Furrion Backup Camera Recommendation for 2018 Cardinal Fifth Wheel Wired for Camera

Question

Question:

Does this system take the place of the Furrion FOS48TA-BL system. We have a 2018 Cardinal Fifthwheel with the wired Furrion mount.

asked by: Richard S

0

Expert Reply:

Yes, if you have the FOS48TA-BL installed in your 2018 Cardinal Fifth Wheel the # FOS05TASF that you referenced would replace that and give you a similar setup but with a larger monitor.

expert reply by: Jameson C

0

Answer 1

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 2

The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the camera.…

view full answer...

Answer 3

We do have what you need, but since your 2022 Winnebago 2529RG is prewired for the Voyager system you will not want to use the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision #ASA57YR that you were looking at. Because you will…

view full answer...

Answer 4

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 5

You can have more than one iPhone "connected" to the Lippert Tire Linc system part #LC37VR but only one can be used at a time. So basically you or your wife could have their phone connected but if you needed to switch between the two phones…

view full answer...

Answer 6

The newer Chevrolet and GM pickup trucks have a known power deficiency issue with the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras #FCE48TASL-05. There is likely nothing wrong that you did, the problem is the…

view full answer...

Answer 7

Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System…

view full answer...

Answer 8

Trailer weight distribution hitches (WDH) such as the Curt TruTrack systems #C17499 and #C17500 do come in varying weight capacities. Selection of the correct one for any given towing setup is based on the actual fully-loaded tongue weight (TW). It…

view full answer...

Answer 9

There isn't an adapter to connect the wiring of a Furrion camera to a Voyager. With that said you can pretty easily just cut the connectors off and then connect to the camera since it's only two wires.

view full answer...

Answer 10

The reason why you would need the #VGR74VR filter to use the #ASA37YR is because your 2022 GMC Sierra 1500 will have pulse width modulation (PWM). This means it won't send consistent power back to the camera and you're going to lose the…

view full answer...

Answer 11

The steps for pairing your Voyager WiSight 2.0 Wireless Backup Camera System #ASA37YR camera and monitor are as follows: 1. Make sure the monitor is connected to 12 Volt DC power supply, but 12 Volt DC power is removed from the camera (clearance…

view full answer...

Answer 12

There is a wireless camera you can use for your travel trailer that will always be on. It is the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision item #FOS05TASF. It comes with a 5" monitor and you will want to wire the camera…

view full answer...

Furrion Backup Camera Recommendation for 2018 Cardinal Fifth Wheel Wired for Camera

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching