Rail Kit Recommendation to Install Draw Tite Hide a Goose Hitch Plate in 2003 Dodge Ram

Question

Question:

Hello I already have the plate and the turn over ball, I would like to purchase only the mounting rail kith is that possible? Sincerely

asked by: Diaz

0

Expert Reply:

That looks like a Draw Tite Hide a Goose Center section like part # 9464 which means all you'd need to install it is the correct rail kit part # 4438 for your 2003 Dodge Ram and you'd be set.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Gooseneck trailer hitch installation kit #4457 is designed for certain 2010 and newer Ram 2500 and 3500 series trucks. It is not a fit for your 2003. The installation kit by itself for your 2003 Ram 1500 is #4438. But these are just the installation…

view full answer...

Answer 2

The Fold-Down Gooseneck Trailer Hitch with Installation Kit, #8339-4438, comes with the hitch, the installation kit, and the hardware needed to install it in the following trucks. 2003 - 2005 Dodge Ram Pickup 6 Foot Bed, 1500 Series 2006 - 2008 Dodge…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Rail Kit Recommendation to Install Draw Tite Hide a Goose Hitch Plate in 2003 Dodge Ram

Products Referenced in This Question

Continue Researching